Faye;

Isn't that what I said?

Jerry

----- Original Message -----
From: "FLD" 
To: 
Sent: Tuesday, February 15, 2000 7:47 AM
Subject: Re: Reply to One Or All?


: Most lists are set up by the listmanager for the replies to be "to the
: list".  The purpose of these lists is to provide information to all the
: listmembers, queries and replies.  In most cases, if you do not enter
: another address, the reply automatically goes to the list.
:
: Faye
: -----Original Message-----
: From: origfatdac 
: To: [email protected] 
: Date: Tuesday, February 15, 2000 12:26 AM
: Subject: Re: Reply to One Or All?
:
:
: >Joe;
: >
: >I used Outlook Express "Reply to All" for this reply. Note that it goes
: back
: >to the list and also to you. I tested "Reply to sender" and the reply was
: >only addressed to you. And, yes, on some occasions the "Reply to sender"
: >will be routed back to the list address only, but not to any coding on
your
: >part.  This is dependent on how the list owner or a person where the list
: >postings are actually sent from.  The option is their's.
: >
: >JerrySanford@EttersPA
: >
: >
: >----- Original Message -----
: >From: "Joe Jones" 
: >To: 
: >Sent: Monday, February 14, 2000 8:16 PM
: >Subject: Reply to One Or All?
: >
: >
: >: Hello to All,
: >: I have just noticed something that needs to be mentioned concerning
: >replies to postings.  In Outlook Express, and possibly other e-mail
: >programs, you have the choice of clicking on "Reply" or "Reply To All".
: >DON'T BELIEVE IT!  Most of the time, clicking on "Reply" will send it to
: >"ALL" anyway.  This is true whether you subscribe to the List or to the
: >Digest.  I'm sure someone can explain what causes this to happen, but
that
: >is not my point.  The point is that the previous suggestions for sending
: >certain replies only to the intended receipient and not to the whole list
: is
: >one of the best ways to reduce clutter, but you must be careful that that
: is
: >what happens when you think that's what you are doing.  Just be sure that
: >the correct address appears in the "To:" window - don't depend on what
you
: >thought you did.  You may have to pick up the individual's address from
the
: >body of the message that you're responding to.  Just remember, the
address
: >that appears in the "To:" window is!
: >:  where it is going to go.
: >:
: >: Thanks for reading.  You might want to run your own test if you have
any
: >doubts, but don't hit "Send" unless you want it to go.
: >:
: >: Joe Jones, Chairman
: >: OGSGS Computer Users Committee
: >:
: >:
: >:
: >
: >
: >
: >
: